$!USERFEINIT.COM---executed automatically when front end processors are loaded
$!
$ RCTL SET CONNECTION ON         ! make 'fe' send data to outside world
$ rctl set scalers 12            ! how many scaler channels do you use
$ RCTL SET FREQ 10               ! how many seconds between scaler reads
$ RCTL SET fraction 1000         ! what fraction of scaler reads go to tape
$ RCTL SET DUMP WORDS 128        ! # of words to dump at once when dump enabled
$!---------------------------------------------------------------------
$! set up the SILENA,CAEN,PHILLIPS ADC's, TDC's by SET INTEGER method
$!---------------------------------------------------------------------
$ rctl set integer 0 1         !SILENA lt
$ rctl set integer 1 255       !SILENA ut
$ rctl set integer 2 80        !SILENA offset
$ rctl set integer 3 10        !SILENA common threshold
$!
$ rctl set integer 4 35        !PHILLIPS lt
$ rctl set integer 5 4095      !PHILLIPS ut
$ rctl set integer 6 0         !PHILLIPS ped
$!
$ rctl set integer 7 2         !CAEN lt
$ rctl set integer 8 255       !CAEN ut
$ rctl set integer 9 166       !CAEN control register (enable,10us gate,gated)
$!                             !48 bit scaler frequency code (0-7=1us-ext)
$ rctl set integer 10 0        !implant clock is at 1 MHz
$ rctl set integer 11 7        !decay clock is in slave mode
$ exit
$!
$ EXIT